View Full Version : Opel Zafira 1.9CDTI EDC16C9 DPF OFF
taurius
13th September, 2012, 08:29 AM
Hello,
I have a big problem with DPF filter on a Opel Zafira 1.9 CDTI with EDC16C9 ECU.
Num. HW: 0281012549
Num. SW: 1037A50279
I have tried Ecusafe, but car has no power and rpm is limited to 2000 rpm.
Please help, Thank you.
mario38
13th September, 2012, 01:14 PM
hello.....
dexik
13th September, 2012, 01:31 PM
Hello m8
Your file fap off with chks OK :)
Pass in pm
taurius
14th September, 2012, 10:49 PM
Tried both files today, sadly none worked, car is still limited to 2000 rpm :(
spawns3
15th September, 2012, 01:18 AM
And about dtc's ? make a log .. This car is two switchs solution.
Cheers
taurius
15th September, 2012, 07:42 AM
DTC tables were deleted in both files, only the single values were a bit different :)
I did try to apply changed bytes from both of the files, but still no power...
After that I found a 12x1 torque limiter, set at 2000rpm and after that it started going, but still not at maximum power.
bursuc
15th September, 2012, 08:12 AM
So....afterall the car is working? :)
Sent from my LG-P970 using Tapatalk 2
taurius
15th September, 2012, 01:03 PM
It works, but not at full power, I think there are still some torque limiters for limp mode.
But it still is hacking, because car is in Limp mode, with torque limiter removed...
spawns3
15th September, 2012, 01:22 PM
Mate if u turn off DPF by switch don't need to delete dtc table , or even change the limpmode torque limiter.
dragosverdes
21st September, 2012, 09:19 AM
Works fine ... thanks
bobolin4o
22nd September, 2012, 08:09 AM
I had same issue - Vectra C... with KTS i made "replace DPF", after that with ECUSafe, done. 10 000 km without problem ... DPF is physically removed, all sensors are still there.
I am not claiming that this is the right solution, but for me in this case is obtained...
spawns3
22nd September, 2012, 04:12 PM
I had same issue - Vectra C... with KTS i made "replace DPF", after that with ECUSafe, done. 10 000 km without problem ... DPF is physically removed, all sensors are still there.
I am not claiming that this is the right solution, but for me in this case is obtained...
Check the oil level , maybe u have a extra oil ;) or not .
Cheers
luca22
19th October, 2012, 01:22 PM
DTC tables were deleted in both files, only the single values were a bit different :)
I did try to apply changed bytes from both of the files, but still no power...
After that I found a 12x1 torque limiter, set at 2000rpm and after that it started going, but still not at maximum power.
Hello Friend,
I have a problem with Zafira 1.9CDTI
"DTC tables were deleted in both files, only the single values were a bit different
I did try to apply changed bytes from both of the files, but still no power..."
Can I Please You to correct for me a 12x1 torque limiter?
Sorry for my poor English
Best Regard's
Edit: Can someone help???
taurius
22nd October, 2012, 09:11 PM
Here is the file, with a modified 12x1 torque limiter.
Mind you - this is NOT a proper dpf off file and use it at your own descretion. This one should give you full power, but you should go to an expert for a proper file. Good luck
luca22
23rd October, 2012, 08:31 AM
Thank's Taurius
I will test and report,
Best Regard's
jarecki55
6th February, 2013, 01:35 PM
need good dpf off to eliminate hardware problem on 0281012549 zafira
dexik
6th February, 2013, 02:49 PM
DPF OFF
Pass in PM :)
jarecki55
7th February, 2013, 11:03 PM
DPF OFF
Pass in PM :)
still do sent work rpm to max 2000
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.