E220 Not starting [Sitemap]

bangreno

23rd September, 2012, 10:20 PM

Hi,
I installed a complete set of EZS , Keys,ESL,Engine ECU , GearBox ECU , ABS ECU on E220 , W210 , engine 611.961.
Key can turn and starter is ignited , but engine don't start.
Scaned with Delphi , live data from EIS is attached.
Please can somebody verify if EIS status is ready to star.
No fault code on Engine ECU , only Injector 3 and 1 Glow Plug problem.

kiantcev

24th September, 2012, 08:44 PM

Can H - not OK "check can wires from eis to engine ecu".

bangreno

25th September, 2012, 04:48 PM

Can H - not OK "check can wires from eis to engine ecu".
Ok , I'll check it .

puu

25th September, 2012, 05:01 PM

Eis Bad....check soldering

finixservice

25th September, 2012, 06:15 PM

as you see injector 3 have problem.possibly cause-1 you change ecu,check injector wire if is in the same pin like old one.and secont i see that from eis you dont have circuit 50.this is eis problem maybe cause of the pin injector dont give it.

cjawahir

28th September, 2012, 01:51 AM

Hi,
I installed a complete set of EZS , Keys,ESL,Engine ECU , GearBox ECU , ABS ECU on E220 , W210 , engine 611.961.
Key can turn and starter is ignited , but engine don't start.
Scaned with Delphi , live data from EIS is attached.
Please can somebody verify if EIS status is ready to star.
No fault code on Engine ECU , only Injector 3 and 1 Glow Plug problem.

hi , do a flow test , mabe one injector is bad , also look at live data of fuel pressure while cranking , sholud be about 300bars , if not engine will never start .

cj