Nissan Murano BCM Swapping

[bangreno]

Hello,
I have 2004 Nissan Murano to Swap , the old one can start the car but doors locks module is burned during Aftermarket alarm installation.
Can I juste Swap EEPROM to the new BCM and use my old keys ?
I don't have a suitable tool to adapt BCM , but I can program keys from BCM.
which of the following solution is possible :
-Swaping EEPROM from old BCM to New BCM
-Program New keys from new BCM (without BCM adaptation).

[VictorBazan]

Hi, replace 93C56, regards

[bangreno]

Hi, replace 93C56, regards
I checked but parts numbers are not the same. So , not worked.
Looking now for BCM pinout (3 plug , 2 white & 1 black).
The fault is fogs lamps and rear wiper remain on , warning lamp not working.
part number is 284B1 CA015

[guillermemosz]

just Need the same used part from other similar car with his pin code, reprogram the original keys, if the BCM is used you dont need to calibrate

[bangreno]

just Need the same used part from other similar car with his pin code, reprogram the original keys, if the BCM is used you dont need to calibrate
Ok , that's good info