View Full Version : Fabia AUB... no idlle
fanos
29th September, 2012, 05:14 PM
Hello. A motor Fabia in 2001 AUB, I idle. If you hold over 2000 rounds go. Error codes not so, and if you remove the EGR connector "spin" like a cat. I put the new EGR, same prob. For gas flow does not affect the EGR put your old jack and stopped. The flap is adjusted, EGR and it's OK (on channel 75 though). I do not know what I'm doing. A suggestion to you would be well received.
Ashraf6119
29th September, 2012, 09:13 PM
Have you checked the MAP Sensor if its not dirty........its located in inlet manifold............
fanos
30th September, 2012, 06:15 AM
If you remove the EGR plug goes in 800 laps. When you plug in the EGR bag, MAP instantly gives me about 800-900 mbar, about 10-12% throttle opens and stops pain. Horror began this morning at startup
gejzaslapka
30th September, 2012, 08:45 AM
if you have inlet pressure 800-900mbar there are only two possibilities - bad pressure sensor or leakage on inlet - you must hear it
GS
fanos
30th September, 2012, 08:59 AM
No plug to EGR, MAP displays about 200-300 mbar. Motor runs perfect, but when put to the EGR plug, MAP displays 800-900 mbar and stops. Stops "cough".
fanos
30th September, 2012, 09:02 AM
I pulled out and plug in the MAP, VCDs displays about 92 mbar. Same problem.
gejzaslapka
30th September, 2012, 09:45 AM
EGR potentiometer value is correct? did you EGR test with VCDS? other parameters are correct?
Ashraf6119
30th September, 2012, 10:51 AM
It could be your EGR valve is shorting to ground................
fanos
30th September, 2012, 04:18 PM
The EGR valve is NEW! same problem...In channel 74 (on VCDS) SYSTEM OK!
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions Inc. All rights reserved.