View Full Version : i can t read fenix 3
tas_daz
12th October, 2012, 07:22 PM
hi my friend i have renault megane 1.4 with fenix 3 and mcu hc11e9 with 4e28b mask.the mcu write hc11e1.i can t read with xprog.i must desolder all mcu ?with upa i can read it or i must desolder?thanks for help
morfej
12th October, 2012, 07:26 PM
You can read it onboard, with upa for shure, I have done it.
obdmaster
12th October, 2012, 07:27 PM
hi my friend i have renault megane 1.4 with fenix 3 and mcu hc11e9 with 4e28b mask.the mcu write hc11e1.i can t read with xprog.i must desolder all mcu ?with upa i can read it or i must desolder?thanks for help
i desolder mcu on fenix3 and use adaptor on xprog. Dont forget to cut immo wire before refitting unit after immo off. :smokin:
tas_daz
12th October, 2012, 08:35 PM
i desolder and i read with upa out on board.but i can t read it like 4e28b.only like secured 0f36w?it is safe?
device is silent says all time.
FXless
12th October, 2012, 09:01 PM
you can read with xprog in circuit without lifting any pin. just follow connection of manual
tas_daz
12th October, 2012, 10:25 PM
i read it with upa but i think the dump is destroyd?can anyone check this ?thanks
if anyone have dump for this with out immo help me.thanks
i read and write eprom or all flash?
thanks
tas_daz
12th October, 2012, 10:42 PM
many thanks to all.with xprog read it and like 0f36w secure i take tyhe same dump and with upa no lift pin.thanks
siegarcia
12th October, 2012, 11:43 PM
file and picture..
Ecu Siemens Fenix 3 (Off) - YouTube
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.