02 Audi A4 brake pad light on dash

[Lexas]

It is possible to switch off brake pad warning in dashboard recoding it. done lots of them. Today did coding on a4, but light still comes ON sometimes when drives reverse or on turns. Fluid level seems ok. any other thing can cause it when function not programed?

[cactikid]

faulty brake pad sensor wire broken can put light on.

[Lexas]

faulty brake pad sensor wire broken can put light on.

even function is disabled in dash?

[Ashraf6119]

What Software Coding did you use to disable brake pad light option......

Also did you try to earth pin A32 on instrument Green/Brown wire see if light will go OFF........

[Lexas]

Usually this light is always OFF, just coming on sometimes and stays till i switch ignition off. after ignition ON, light didn't apear.
I'm using launch x431 to code dash. done those a lot and every time it works, light never coming on again. doing this cause its faster and cleaner job than remove wheels and short wires. but this time not works this solution, just wonder why... want to be sure, that this light coming only for brake pads and any other fault like low level of fluid or sensor gone etc can't switch ON the same light. Will try connect that wire on dash to ground later cause customer far away, just promise him to switch off by coding dash... :D

[Lexas]

today was trying to locate witch pin is brake pads, but unsucsesful. is it possible that information comes by can line? Maybe someone has all dashboard pin connection diagram for audi a4 1.9 tdi '02? Thank You

[smokey08]

Autodata shows pin 32 brown/green wire. Short to earth to turn off light.