CAS3 E60 2006

[Ocin]

Hi All,

Hi have some problem with this black CAS3 mask 1L01Y.

I tried to read with red rosfar clone but it linking 6 times and can't unsecured the micro.
Anyone know why ?
Never had a problem with other mask

Put back in car all work fine.
Regards

[whiskymk]

try with external power ,, or put +5v direct in rosfar

[z786]

make sure xtal wire is extended and also no phones are near it

[obdmaster]

Ive had same problem with 0L01Y maskset with red rosfar clone.

In the end i did it by CANBUS100 using AVDI.

Try oscillator connections as EDR pauli drawing attached, and let me know if it works m8.

You will notice the oscillator connections are slightly different to those in rosfar manual

[drpeter]

Simply use the x12 programmer works fine.

Verstuurd van mijn GT-N7000 met Tapatalk

[mariusz971]

Hi obdmaster, I did like you siad and is working. thank you

[3abas27]

Ive had same problem with 0L01Y maskset with red rosfar clone.

In the end i did it by CANBUS100 using AVDI.

Try oscillator connections as EDR pauli drawing attached, and let me know if it works m8.

You will notice the oscillator connections are slightly different to those in rosfar manual
WHTS YOUR MEANING WITH CAN BUS 100 BECAUSE ME ALSO HAVE SAME PROBLEM WITH MASK FOR BLACK BMW CAS 3

[pepi]

Can bus 100 is used with AVDI interface with CAS plug directly on CAS. So , if you dont have AVDI dont think about it.