mathura
26th October, 2012, 06:06 AM
Hello DK Friends
This one is for the experts, I need to install Calibration File in ECM, has not done this before and need guidance.
This is what I did but not succesful so far
1.I installed the file in calibration workspace
2.I connect to ECM and opened calibration selection
3.A red dot was shown next to calibration workspace
4.I clicked on it and a drop down box opened, then I clicked on automotive
5. The cal file appeared yellow in colour
6.When I clicked on the cal file then I get a message in the right hand column
"INSITE could not detect calibration for the selected ECM"
What am I doing wrong please advise
Thanks for any help
This one is for the experts, I need to install Calibration File in ECM, has not done this before and need guidance.
This is what I did but not succesful so far
1.I installed the file in calibration workspace
2.I connect to ECM and opened calibration selection
3.A red dot was shown next to calibration workspace
4.I clicked on it and a drop down box opened, then I clicked on automotive
5. The cal file appeared yellow in colour
6.When I clicked on the cal file then I get a message in the right hand column
"INSITE could not detect calibration for the selected ECM"
What am I doing wrong please advise
Thanks for any help