PDA

View Full Version : E320CDI V6 DPF



aidyk
27th October, 2012, 11:52 PM
tried using ecu safe but now car has no faults but limp mode and 3000rpm max. i read somewhere here before that ecusafe can have this effect.
can somone help me ??

rabie_m
28th October, 2012, 02:09 AM
check this dump end send raport

mercis
28th October, 2012, 05:03 AM
tried using ecu safe but now car has no faults but limp mode and 3000rpm max. i read somewhere here before that ecusafe can have this effect.
can somone help me ??

ecusafe can only errorcode disable
not dpf,

autotuner1985
28th October, 2012, 09:05 AM
ecusafe 2 and volta not work on this cars, only erased ALL DTC's

aidyk
31st October, 2012, 11:35 AM
check this dump end send raport

hi only getting back now im going to try this now my friend ill report back :)

aidyk
31st October, 2012, 12:01 PM
hi only getting back now im going to try this now my friend ill report back :)

ok i reprogrammed with this software and i thought all was good as soon as it started revved up over 3000rpm no problem so i take for drive and only rev to 3000rpm again. so i realise now that when i start car only rev up for 1st 2 or 3 secs then back to limp any suggestions please..??

assitutto
31st October, 2012, 12:17 PM
try and report, pass in PM

aidyk
31st October, 2012, 12:38 PM
try and report, pass in PM
thanks for that but 3000rpm max same as last 1 i tried full rpm for few seconds then 3000max

assitutto
31st October, 2012, 01:34 PM
have you dtc in ecu?
have you post ORI file or ECUSAFE file??? :ahhhhh:

Post ORI file and i think i can help you.

macxlulu666
31st October, 2012, 01:35 PM
Mb is very easy soft to dpf off but no ecusafe tuners....

mercis
31st October, 2012, 04:30 PM
thanks for that but 3000rpm max same as last 1 i tried full rpm for few seconds then 3000max

ecusafe shit dissable your dtc table
limp mode and no errorcode
load ori file back and read errorcode

furnata
31st October, 2012, 07:46 PM
And your diferential pressure sensor must be ok (working condition)
You remove DPF from car (hardware)?

aidyk
31st October, 2012, 08:04 PM
And your diferential pressure sensor must be ok (working condition)
You remove DPF from car (hardware)?
yes dpf removed from car freeflow now.

aidyk
31st October, 2012, 08:05 PM
have you dtc in ecu?
have you post ORI file or ECUSAFE file??? :ahhhhh:

Post ORI file and i think i can help you.

hi yes its ecusafe i sent i didnt have original from car but i have got it now from other guy who read it at the begining.

here is original from car

zoyzoyni
31st October, 2012, 08:06 PM
best way for solusion is mercis opinion.write again ori file and post your dtc codes.

aidyk
31st October, 2012, 09:11 PM
best way for solusion is mercis opinion.write again ori file and post your dtc codes.
ok ori posted there above , i reflashed it and read codes with launch they are 2078-2 and 2626-1

regards

aidyk
2nd November, 2012, 05:55 PM
FIXED :) car going good thanks all.