Marelli multijed BDM connection

[darius89]

Can anybody confirm my BDM connection for marelli.
Red first wire should be like in picture or on red dot.
Added edc16 connection Tested to confirm where 1-red wire.

[adusia123]

Can anybody confirm my BDM connection for marelli.
Red first wire should be like in picture or on red dot.
Added edc16 connection Tested to confirm where 1-red wire.

red bar pin 1

:wink::wink::wink::wink:

[darius89]

So looks like my connection OK..

[smayer]

Connection ok, dont forget remove resistor.

[jaelgti]

Hi guys.
I think here is a little clearer.

[darius89]

Thanks for help to connect... One more problem tried to read and get error on screen in picture
and let to read only advanced file which after usinh export to bin looks ok.
Does problem in my bdm ???

[jaelgti]

Hello darius89 I utilizao this program DIMSPORT,I use cmd, then I can not advise.

[darius89]

Hi, Installed new soft MPCPROG but situation same , but reading different from previous soft.
Let me read only one file ( advanced not active ) file size 512 kb.
Does FGTech (http://www.obdauto.com/views.asp?hw_id=1985) reads well?

[pablo1971]

hello darius89 (http://www.digital-kaos.co.uk/forums/members/125075-darius89/),i too have done this ecu....i tried bdm100 on dimsport software---INCORRECT FAMILT---i then tried BDM100 ON CMD SOFTWARE----INCORRECT FAMILY....after rebuilding ecu i found cmd had removed the injector codes.....SO I READ AND WRITE THIS ECU WITH GALLETTO 2 CLONE----100% WORKS,with obd not bdm

[mario38]

Hi, Installed new soft MPCPROG but situation same , but reading different from previous soft.
Let me read only one file ( advanced not active ) file size 512 kb.
Does FGTech (http://www.obdauto.com/views.asp?hw_id=1985) reads well?
I sent bdm update to your inbox .. hello