PDA

View Full Version : citroen c4 2005 bsi 95128



batpepi
31st October, 2012, 11:10 PM
need 0km or 107254km bsi johnson 95128
actual mileages is 254700km
thanks

elektro128
31st October, 2012, 11:21 PM
need 0km or 107254km bsi johnson 95128
actual mileages is 254700km
thanks

hi
107254km

regards

batpepi
3rd November, 2012, 11:57 AM
The car can`t switch on ignition.It is totaly dead.I try to put back original file 95128,but same.
Can someone make this file virgin and tell me procedure for learning.I can`t connect now with lexia without ignition on.
pin is 3H3E
BSI Johnson controls
9661940180
BSI2004 H02-01240206
boot 21676031-5B
hard 28117431-0A
V02-00
Thanks advance

batpepi
3rd November, 2012, 01:55 PM
i put whole file fith fffff...no ignition switch on

aeroyas
3rd November, 2012, 02:53 PM
check electrical fuses, and resistance near eeprom at BSI

swingman26
3rd November, 2012, 03:00 PM
Check also soldering 95128.

batpepi
3rd November, 2012, 03:12 PM
soldering is ok,i check many times.
What you mean electrical fuse?Inside in BSI.mikrofuse or this outside?
Outside all is ok.

aeroyas
3rd November, 2012, 05:18 PM
sure? all is ok? i think that you have broken the bsi, try with another bsi and report, if the ignition is on with other bsi change your's

batpepi
4th November, 2012, 12:21 AM
all is ok,yes.
i check with other BSI and it have comunication.
Strange is that,i only desolder 95128 and read it,after that solder.
I found same BSi,difference is only
BSI Johnson controls
9661940180 -this number is same
BSI2004 H02-012 4 0206 ori
BSI2004 H02-012 3 0206 new
if i change 95128 ,possible work without any other procedures?

coelhone
4th November, 2012, 12:26 AM
yes, but try in other eeprom because your first dump can be corrupt.....

batpepi
6th November, 2012, 09:36 PM
i get new BSI,put original read file from old bsi.
now switch ignition on ,but still not start and have 0km on dash and all systems blink with problem on display.
If i write all 95128 with ffff ,can i make right configuration and start the car?
Why not work with original data?Stored configuration is not only on 95128?

apolo2100
6th November, 2012, 10:58 PM
you can put the data OriginaI, but will have to program the keys.ou put everything (ffffffffff) in 95128 and reprogram the lexia

batpepi
6th November, 2012, 11:03 PM
thanks,
first will check with lexia and original data,if can`t relearn key,will fill with ffff and will make new configuration.