View Full Version : Problem with UPA USB and NEC adapter
didi_du_93000
6th November, 2012, 12:27 PM
Hello All,
I have try to read a NEC UPD78097.
I have 2 UPA USB, 2 NEC adapter.
I have tested In circuit and On board.
I have lifted Reset pin, Vdd pin And EVen ALL PINS!!!
But always same result!!!
BAUDRATE ERROR!!!!
I have check all connexion. All is good.
Anyone can help me?
antibisic
6th November, 2012, 12:38 PM
Did you removed J3 jumper?
didi_du_93000
6th November, 2012, 02:57 PM
Did you removed J3 jumper?
No i have tested the two position but no sucess.
You think i need to remove this jumper?
Sent from my BlackBerry 9900 using Tapatalk
antibisic
6th November, 2012, 04:31 PM
Yes remove it and try,upa reads nec very easy
didi_du_93000
6th November, 2012, 07:53 PM
same result
Sh**!!!!!
gadroulll
6th November, 2012, 07:54 PM
can you send a photo with the connections?
didi_du_93000
6th November, 2012, 08:12 PM
can you send a photo with the connections?
I have found the problem...
It's not my UPA, it's not my connexions...
It's the MCU is dead!!!
I have kill it.
I have try with another dash and full working.
faiscamix
6th November, 2012, 08:12 PM
Check connections and see wich crystal it have. I had some problems also but when you find right baud it start to work nice.
Best regards
didi_du_93000
6th November, 2012, 10:43 PM
Check connections and see wich crystal it have. I had some problems also but when you find right baud it start to work nice.
Best regards
I have tested and cheked all connexions.
MCU is dead.
Anyone have full memory of dashboard 307 2003 with NEC inside
Sagem T5-1
V20.09
Nikola123
6th November, 2012, 11:41 PM
You need eeprom of this mcu?? flash part you can not programing with upa or nec programmer
didi_du_93000
7th November, 2012, 12:11 AM
You need eeprom of this mcu?? flash part you can not programing with upa or nec programmer
Yes you have right... I have forget than upa can write just eeprom.
I have asked flash because i have a new upd78.
So I must buy an other dashboard.
Thanks at all.
I have killed this mcu with my enigma... I have forget to put the adapte before read mcu.
Shit and stupid mistake!!!
Sent from my BlackBerry 9900 using Tapatalk
didi_du_93000
7th November, 2012, 10:26 PM
Are you sure upa can't write full memory of nec mcu???
I know for motorolla mcu but i haven't read it for nec mcu...
gadroulll
9th November, 2012, 04:34 PM
it think that you can
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.