Nissan 2010 TIIDA(VERSA) problem..

[ajman5252]

Hello Guyys

Once again need ur guys help!!!!

I had a customer this morning with 2010 Nissan Tiida...BCM no:80556, With help of a DK fellow, I got the pincode:5009

T300:
Put the new key..>Went type 9---> NATS 5 KEY--->finally Key programmed msg came..security light went off. I removed the key and tried to start again but security light came back.

Tried the customer key, security light is on again. So i once again programmed customer key, security went off, removed key, switched on the ignition, security blinked for five times and went out and car started. So customer key is fine now.

But new key, i did no:of times, same thing happens. Security light goes off at programming stage but when u pull out the key and turn on again, light comes back!!

SBB:
Fed up with T 300, i got SBB and---> went Tiida NT5. it says to '"insert new key in sequence and on and off 5 times respectively'".. didnt exactly understand the procedure!! anyways tried and but no gain

IS this common with Nissan?? or did i do the procedures wrong. I have very less experience with Nissan. or maybe is it because of wrong pin??
So anyone can tell where did i go wrong??

Your Help is much much appreciated!!

[ajman5252]

Anyone.....plsss help me out!!!!!

So i am sorry i cannot post the dump here...bcoz i still hasnt reached to that level of expertise

[keygargoil]

on most nats using id46 or pretty much any other immo once you have erased the keys cycle all the keys you want to programme and your done is your key locked because you cant reprogramme a locked key

[ajman5252]

on most nats using id46 or pretty much any other immo once you have erased the keys cycle all the keys you want to programme and your done is your key locked because you cant reprogramme a locked key

I guess u r 100% rite..This would be reason, bcoz the transponder could have got locked at the first programming and may be coz of it, i cant reprogram it since it is locked!!!

Ok i will try with new tranponder..

One doubt though: when i start programming on T300, should i start( turn ignition on) with customer key and them swap to new key OR should i start with NEW key all the way till programming finishes.

Thanks a lot for ur reply...
:ciao:

[abuuauto]

hi. you can use blank pcf 7936 chip it work fine on nissan tiida .sbb too it good you can program like tiina it comunicate fine.