Renault ABS ERROR

[joaopereira]

megane 3 2009

After correction km?s in ABS in DASH
show in the Dash error Abs permanent
anyone ever had this problem?

someone can help me ?

thank you

[cokolo]

Which device are you using ???

[mastaflex]

Did the error appear directly after reassembling parts or after some time?


Sent from my iPhone using Tapatalk

[alfabit]

megane 3 2009
After correction km?s in ABS in DASH
show in the Dash error Abs permanent
anyone ever had this problem?


All the help you will get from Clip sonde, reading the errors ( if present ) or reset the ABS dash error led.
Can be many failures, nobody can guess what happens in your car, but Clip tells you the failure.

[joaopereira]

hi
i read abs eeprom 95160 outside and 24c16 dash
this error appear after some time
Clip sonde, reading the error ABS ( present )
thanks

[mastaflex]

ABS block have problem inside due to wetness because it was not good sealed

[almeida]

Solution is easy
Post dumps after and before
The problem is at the dumps for sure at the calculation
You desolder 24c16 ?

[joaopereira]

hi
yes, i desolder 24c16 in dash
would be possible to verify the dump 95,160 abs
thanks

[almeida]

hello
no dumps
please post after and before

[andy99]

megane 3 2009

After correction km?s in ABS in DASH
show in the Dash error Abs permanent
anyone ever had this problem?

someone can help me ?

thank you
your problem
no brake oil :(

[andy99]

put here dumps

[joaopereira]

first post

[joaopereira]

first post dump abs

[joaopereira]

hi
possible someone would help me
I think this corrupt dump abs
help me
thanks
http://www.2shared.com/file/DenaEqih/ABS_95160_73884kms.html

[andy99]

clean your PM
dump is good

[badenaleks]

Mileage on the dump in 5 locations!

[badenaleks]

D3 F6 24 BD = 73884

[joaopereira]

thanks i try and report

[fes_786]

would also help if u told us what tool u use to do abs dump

calculator, dp3, enigma .etc

[joaopereira]

hi
your dump it's ok, thank you
but i have another problem
ABS block have problem inside due to wetness because it was not good sealed
Masterflex this right
thanks to everyone who tried to help me