need pin for clio y2000

[diga1]

hello here i have non starter clio and need pin code to code keys again so can someone give me pin from uch dump eprom is 93c46.
funny thing vhen i pu key in zedbul key fob it doesnt rcognise transponder. it says no transponder.

[esse]

hi,
pin:4185

[helmi reguig]

hi,
pin:4185


BMT SAGEM

:driver:code pin 4185
_______________________________

[coolsoda]

If your zed bull says no transponder,your key is faulty ,very common,if your key was ok you can read pincode from key with zed bull

[coolsoda]

If your remote is still working ,produce a new transponder in zed bull (Extended Function 16)cut of rectangular coil in key and replace with new transponder.

[diga1]

vhat is the typ of transponder i have to use vth this kind of key

i am a bit new in locksmith so any help vuld be gratefull

[topclef]

i am a bit new in locksmith so any help vuld be gratefull[/QUOTE]

ok , we understand .

use transponder : Silca T5 or JMA TP05 and Write these logic data and start your car :driver:, using Silca RW2/RW4 or similar to write these data .


30 3F 70 00 F8 01 1C 00 00 00 07 F0 E3 38 7E 00

[tas_daz]

if have big batery is 33 if have smal is id46 and new clio2.broke the coil and don t work.change coil from other key or programme chip

[diga1]

can zedbull program t5 transponder

[coolsoda]

What have you been using your ZedBull For
Main menu enter digits in the boxes and copy to a T5 or You can reuse an old PCF7931
Or enter your dump in the correct module and it will make one for you.

[diga1]

hello i have vritten this data to a t5 transponder using effi and zed bull
but immo light still blinking
can anyone tell me vhat is original chip in this clios
shuld i do coding vith clip or car shuld start emmidiatly vith this data?


QUOTE=topclef;1789000]i am a bit new in locksmith so any help vuld be gratefull[/QUOTE]

ok , we understand .

use transponder : Silca T5 or JMA TP05 and Write these logic data and start your car :driver:, using Silca RW2/RW4 or similar to write these data .


30 3F 70 00 F8 01 1C 00 00 00 07 F0 E3 38 7E 00 [/QUOTE]

[ninja123]

your pin is defo correct - your system is id33 NOT ID46.

If you use EFfi or zedbull software, you will get same result - and for the life of me, I cant understand why you asked for pin code if you have this equipment!!

Immo light still flashing?? can only think that you have mad a mistake or used wrong transponder.

You can use T5 or pcf7931/7935

ninja

[cleevesy]

Check the coil on the remote they tend to snap off , solder back on read the key then write to a t5