xsara picasso, berlingo ...nec bsi solution_

[nebojsapejcic]

Has anyone tried this pinout with DP3 , looks easier (don/t lift any pins)? I guess 13 and 14 are 5v and ground
I attached dp3 and other solution

[cokolo]

I put these picture on DK long time ago and work perfect with NEC programmer but for Dp3 I don't now , sorry :-(

[nebojsapejcic]

Yes , I download from you, thanks for that! Can you tell me for number 13 and 14 wire, is that 5v and Ground
?

[cokolo]

Yes , I download from you, thanks for that! Can you tell me for number 13 and 14 wire, is that 5v and Ground
?

For wire number 14 I am sure is GND but for wire number 13 I am not sure :questionmark:

[almeida]

hello cokolo
this pinout work with upa without lift pins?
when i use upa i must lift two pins and conections are different

only now i see with your pdf i must raise a pin from a big mcu. but is easy

[markony79]

Has anyone tried this pinout with DP3 , looks easier (don/t lift any pins)? I guess 13 and 14 are 5v and ground
I attached dp3 and other solution

LIFT UP pin nr 10 , if you do with Dp3

[ALEXEI]

dp3 fail to make this mcu. I never succed. made only with etl nec programmer and tachosoft algo
on pdf red wire is 5v and black is gnd.

[bodzio012]

Only good programmer or UPA

[nebojsapejcic]

dp3 fail to make this mcu. I never succed. made only with etl nec programmer and tachosoft algo
on pdf red wire is 5v and black is gnd.

Thats strange! I've done many nec dashes 100% with dp3. I just don't like to lift pin because few times It got disconected and car don't start after few days. Then I had to resolder

[javilette]

dp3 works whit this but is not the best for this mcu. whith dash for example 307 works fine but whith bsi you have to risk if dont read ok , change the file and you have problem neec to put viging and code whith lexia

[alclot]

Hi friends. Have you got instructions to read with the UPA, the micro NEC?
Thanks in advance ;)