read with xprog hc05b32 0d60j

[tas_daz]

how i can read with xprog the hc05b32 0d60j mask?from athos air bag?95910-05600?
i put 9 cables but said device silent in circuyit but nothink.i must take off?thanks

[tas_daz]

i have and upa,try it?read with upa?

[engvitinho]

i have and upa,try it?read with upa?
changes oxilador 8mhz
0d60j-68hc05b16

[tas_daz]

the mask said 0d60j and it is hc05b32 and the ecuvonix air bag said 05b16?what i do?

[tas_daz]

i try and 8000000

[engvitinho]

read upa
8mhz
lift
p1,p2,p3,p4,p7

[oeplopel]

see on picture connection

[tas_daz]

my friends i desolder and on board with xprog like 05b32(0d60j)mask and read ok.and do bypass to read.
i post the file and clear with ecuvonix air bag.if someone do this ecu please check and help me if the file is good.

[conan981]

i want to share my little experience with HC05 using xprog-m clone.
tried to read plcc 52 using connection into xprog-m manual (6 wires) but i always failed with error DEVICE IS SILENT.
Then, i desoldered the plcc52 and read the plcc using HC05Bx adapter that come with programmer and i can read/write successfullY.
Now, any of you succeded in read/progam HC05 device "on board" without desoldering the mcu?
thanks
Conan

[bulanbulanov]

my friends i desolder and on board with xprog like 05b32(0d60j)mask and read ok.and do bypass to read.
i post the file and clear with ecuvonix air bag.if someone do this ecu please check and help me if the file is good.
You must put FF instead of 00 at $02F in yours ecuvonix cleared file

[buenasuerte]

hello boys...
To read 0d60j-68hc05b16 with UPA.
Lift P1,2,3, 9. in circuit

UPA forever!!!