PDA

View Full Version : where is satelite stored position list kept in vu+ dou



the goat
14th December, 2012, 11:36 AM
hi
been trying to setup my motorised disc no and off for months now
finally got it sorted (had probelms with trees, dish size, motor,) for a five minute job this has been agro

what i've found is the motor is not tracking the arc right
if i setup 28e at 99% 19 13 10 7 all ok but 4.8e 8w are miles out, i have to do tiny moves west on the disc motor
so it looks like usals not working with my motor

so i'm going to move disc by satelite postions,
where do i find the satelite stored postion list that the vu+ duo uses
see how to do it in my old dreambox, but can't see it here

benny/9
14th December, 2012, 07:00 PM
hi
been trying to setup my motorised disc no and off for months now
finally got it sorted (had probelms with trees, dish size, motor,) for a five minute job this has been agro

what i've found is the motor is not tracking the arc right
if i setup 28e at 99% 19 13 10 7 all ok but 4.8e 8w are miles out, i have to do tiny moves west on the disc motor
so it looks like usals not working with my motor

so i'm going to move disc by satelite postions,
where do i find the satelite stored postion list that the vu+ duo uses
see how to do it in my old dreambox, but can't see it here
**************************************
if your motor is set up correctly and you have the correct long/lat settings
the motor will find all the sats. if you want to use diseqc 1.2 settings you
have to select advanced in the tuner config and give all the sats you set a different number, so if you start at 30w as number 1 and go to 15w that will be 2 and so on for all sats you want on your list

jimleeds
14th December, 2012, 09:13 PM
I was having same problem with my motorised setup adjusted elevation a couple of degrees and all was fixed think it has around 75-90% on most sats instead of being high on 28.2,19,16,13 e and nothing on the west side

the goat
15th December, 2012, 08:09 AM
thanks guys
my nieghbours tree is right in the path of the signal
had to put a longer pole up to get the signals,
i'll go up there ladder again and just give it a little bit of up and down movement on the dish