F-100 (Dutty) and 9S12H128VFV

[guillermoc]

Hello, I need to help me connect this microprocessor 9S12h128VFV the Ford F-100 (Dutty) I use programmer-box Gold v 1.54, I still serves to indicate the position I Bckgd, Reset, Ground 5Volt, thank you very much.

[marcio1758]

put a picture of the rear of, and has two plugs, blue and black?

[guillermoc]

Hello Marcio1758, yes have two plugs, blue and black.
If you need to send a picture of the back, has a flexible transparent plastic plate.

[marcio1758]

I think I can help! see this scam!

[guillermoc]

Thank you very much for your help, I will use it at a time, thanks again.:top:

Yes, work excelent!

Any more question, do you have pin connection in black or blue conector?

[guillermoc]

Oh Marcio, Install it on the vehicle and the mileage has not changed (296,427 Km) but the programmer read desired mileage (160,000 Km) read as F150, you know what will happen?
I change some crystal?, thanks for your help.

[guillermoc]

Rear Panel F-100

[marcio1758]

Read and edit the dump manually, the lines must be so!
0F10: xx xx xx xx xx xx xx xx xx xx xx xx 30 D8 xx xx
0F20: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F30: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F40: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F50: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F60: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F70: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F80: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx
0F90: 30 D8 xx xx 30 D8 xx xx 30 D8 xx xx xx xx xx xx

any doubt post the original dump tachosoft but is capable of doing!

[marcio1758]

here is the link plugs!

[guillermoc]

Marcio Thanks again, the problem that presents itself is that "Gold-Box v1.54" in F-150 modifies only the end of the line F40 to F90 and F10 does not touch the lines, the option F-250 recorded in the same places, in conclusion did not modify the lines from F10 to F40, will not let me manually the "Gold-Box" or I do not ....
Tank you for connection!