vito cdi 115 p2537 Glow plug control module - short/open circuit

[rrguillaume]

hello , I have a vito cdi 115 with the default code P2537
(Glow plug control module - short/open circuit), not the clear, I change spark plug and relay still the same even unplug it gives me in erreure permanent. you have an idea? thank you guillaume

[daniersms]

Yes open the relay and you will find that the in- line fuses (sort of) has burnt off ---Repair those and it should work

[rrguillaume]

Hello, disconnect the relay with two lugs to remove allimentation there is always the default. And I even replace the relay with two new but it changes nothing. Thank you thank you good reveillion

[kuzmichh]

Check Power supply and earth to relay

[rrguillaume]

Yes but when I unplugged the two are taken on the default relay remains the same is no other default it adds? ca would take to burn? thank you

[Bazil_mb]

Hi,
In glow plug relay is 4 fuses looks like a wire.If you have a shortcircuit glow fuses blow and fault remain till you solve the fuses. Daniersms have right
Regards

[genius76]

I think I should, help where trouble if the relay is okay

http://foto.terpe.lt/inkelti/20130101/i9_untitled.JPG

[kuzmichh]

I think I should, help where trouble if the relay is okay

http://foto.terpe.lt/inkelti/20130101/i9_untitled.JPG

On screenshot you can see what you need to test.
Wiring from ECU to Glow Relay, short to earth, short to +B.
Only 1 wire.
If you need schematic diagram , post here VIN or in PM.