Chevrolet Barina programming help

[ajman5252]

hello DK friends

I have customer who has chevrolet barina 2002(also known as holden barina) lost all keys
i paid dealer and got the pincode which is 1041

When i try to program key thru sbb, it says to switch ignition and insert pin code and switch on... then i get message of "ECU Disconnected"!!

Can anyone help out or any alternate ways??

i paid heavy for the dealer for pincode and keycode and i dont want to lose the customer as well...

[ajman5252]

i used 4d60 chip while programming...is it the right one???

[genius76]

Try not completely off, just over one position, not fully

[ajman5252]

can anyone confirn the right chip 4d60 or 46 which is used in this car!!

[Automat]

Phillips crypto 40 according to JMA catalogs

[keysph]

Post a picture of the car (and a VIN would be nice) to see it because the internet is very confusing. It show Chevrolet aveo and Opel Corsa C.

From Silca key program it say must be ID 40 chip under Holden.

[keygargoil]

the barina is id40

[ajman5252]

Thanks a lot guys:jiggin:!!!the car was finally got programmed, and you all were right, it uses id40 transponder..

for future reference: Sbb wouldnt do it, it was done by t300 under GM/OPEL--->AUS---> BARINA C---> special function--->Program key--->insert pin code--->a couple of msgs to switch off ignition on n off and finally what i wanted to see...Key Programmed!!!

Once again thanks a lot !!!!!!

[keysph]

Did you try on Corsa C wirh SBB and did not succed?

[ajman5252]

Did you try on Corsa C wirh SBB and did not succed?

NO I DIDNT TRY IT YET, I STILL HAVE CAR WITH ME, I WILL TRY AND LET U KNOW