PDA

View Full Version : galletto boot mode question



kuti
7th January, 2013, 05:01 PM
Hi
Just starting my experience with galletto.
How to enter boot mode of proc. (using galetto correct sequence)

I try read ME7.9.5 (C1) do it like tihs:
1) connect like in pic pin 4 pcb to gnd and 6 to 13. (with 1K resistor)
2) power supply to ecu.
3) disconnect both (6 with 13) and 4 form gnd
4) read file

and got error.

any idea ?

sunduk112
7th January, 2013, 05:46 PM
share foto where is see manual conection

kuti
7th January, 2013, 06:46 PM
Photo.
Question how to enter boot mode.

Connect like in picture and power on 2-3s and disconnect both resistors ? after that i press read but error apear.... not in boot mode
K line work because when i select driver citroen c1 etc. I can read ident of ecu via k lnie in "car" mode not "boot" I hope you knwo what i mean :)

fulvio.carretta
7th January, 2013, 07:01 PM
maibe u are using the wrong k-line, on Galletto not clone the k-line is the green cable not blue

kuti
7th January, 2013, 07:04 PM
cable and connection is ok because i'm able to communcate with ECU even write file to ecu but not in boot mode.