Transit 2006

[emiliogsm]

Hello all , can someone explan key cycle procedure after key erase with IDS .
i have a Transit with reflashed BCM and without original keys.
So now in BCM i have 0 keys and need to mached a new 2 .
I try to add key but after write incode IDS ask to turn Off then on ignition and to klick tick button , i am make it this and after that noting hapend .....
so need step by step procedure to add a keys if is possible

thanks in advance

[whiskeyman]

firstly is it a clone ids

[milesahead]

Hello all , can someone explan key cycle procedure after key erase with IDS .
i have a Transit with reflashed BCM and without original keys.
So now in BCM i have 0 keys and need to mached a new 2 .
I try to add key but after write incode IDS ask to turn Off then on ignition and to klick tick button , i am make it this and after that noting hapend .....
so need step by step procedure to add a keys if is possible

thanks in advance
Hi whiskeyman , the procedure is quite simple , you just go to ....

parts functions, add key , get outcode info, enter incode info it will then ask you to switch ignition on with new key within 5 seconds , do so then do the same with other key then it will start.

i have also heard that the clone ids sumtimes doesnt recognise the ignition going off and on and this would cause a problem when coding keys mate.

hope this helps you.

h

[whiskeyman]

hi h

i was just going to say that about the clone lol

[emiliogsm]

firstly is it a clone ids
yeah its a clone , but never have a problem before .

[milesahead]

yeah its a clone , but never have a problem before .
Try this....

When it asks you to put ignition on you usualy have 10 seconds so when it says put on do so and wait 9 seconds before hitting tick as it will give the clone more time to pick up ignition going on !!

give it a try and let us know.

[emiliogsm]

Try this....

When it asks you to put ignition on you usualy have 10 seconds so when it says put on do so and wait 9 seconds before hitting tick as it will give the clone more time to pick up ignition going on !!

give it a try and let us know.

i am try , no result .i am test a power on and power off detection all is ok . when i put key in off position and press tick button and put key in on position , pats LED stop blink

its possible to add key manualy ... ?

[nutloose]

do you have the RIGHT TRANSPONDER in the key?
W1 carbon I think.
I have had keys supplied from dealer that had glass transponder when a carbon one is specified

PS: PATS light always stops blinking when in security function and NO manual procedure

[emiliogsm]

yeah i am use a carbon TP20 4d63, also try with both transponder from other Transit 2006

[keysph]

Try using ID60 chips. Transit use id 63 after 2007 ;)

[rapidlocksmiths]

agree , try using ID60 glass chip as transit used these until the new id63 chip in the blue remote in 2007 onwards , if a 2006 then you should be using 4d glass id 60

[emiliogsm]

i will try today .Thanks for hint