PDA

View Full Version : Problem with FGtech and bmw edc17



z786
12th January, 2013, 09:45 PM
hi can some1 tell me what these errors mean plz
same ecu will not go into boot mode

thanks

J_amb_o
12th January, 2013, 09:49 PM
It has detected TP. It will not go into boot because the TP level is too high for the clone.

z786
12th January, 2013, 09:53 PM
im using magpro x17 to put it into boot

ecu is from a 2008 bmw its a cp02, didnt know it had TP?

i was just using fgtech for obd flashing

J_amb_o
12th January, 2013, 10:21 PM
So will it go into boot or not? Will the X17 not flash OBD?

z786
12th January, 2013, 10:24 PM
its not going in to boot
havent tried flashing it using x17

z786
12th January, 2013, 11:52 PM
somebody must know what CKWR2 must mean???

z786
13th January, 2013, 12:01 PM
Bump .....

pjrevs
13th January, 2013, 12:05 PM
im using magpro x17 to put it into boot

ecu is from a 2008 bmw its a cp02, didnt know it had TP?

i was just using fgtech for obd flashing

Its not matter if is 2008 and CP02, if car is updated by dealer then is software newer with TP. Use boot mode, because FG cant made CHK.

z786
13th January, 2013, 04:19 PM
Ecu is not going in to boot either

ecutuners
13th January, 2013, 04:25 PM
use this boot pad mate

Babos
13th January, 2013, 04:25 PM
hi mate for boot mode is very inportant good connects to pin!!!
i befor do same ecu and have problems after i made good connects and all be fine!

z786
13th January, 2013, 05:09 PM
already tried that boot pin aswel mate :(

ecutuners
13th January, 2013, 07:17 PM
Solder the wire directly to the pad instead of using frame mate its a better connection cos that pad is very small