i need rpm increase when hot

[pablo1971]

can anyone help me,i need to raise the rpm on this car
SEAT IBIZIA 1.9 TDI 130
-038998019C
-0281011720
-369445)-

[Stanton]

What difficulty are you having trying to do this yourself?

[super jumbe]

Very difficult no more idling screws all electronics that?s why he is asking for help? http://www.digital-kaos.co.uk/forums/images/smilies/hmmmm.gif http://www.digital-kaos.co.uk/forums/images/smilies/hmmmm.gif

[pablo1971]

to be honest,its something ive never had to do,so struggling to find

[Stanton]

There's a difference between asking for help and asking for a job to be done for you.

Asking for help would be "what calibratable values or tables limit Nmax? "

[Stanton]

Have you been able to define any of the maps etc? If not that's your starting point. Or find an A2L for this or similar software version and work from there. Thanyou will see its not so hard.

What rpm are you wanting to achieve?

[Meat-Head]

There's a difference between asking for help and asking for a job to be done for you.
"

i was thinking "go see a doctor" when i read the title

[pablo1971]

i was asking for help,i dont expect a "there you go mate password in pm" answer....like i said,its something ive never come across before,

as for maps and definitions yes got most of them sorted for general maps....but rpm takes some finding...


having had a good look i think im in the right direction...will test and report the results

[Stanton]

Ok...well in short rpm is governed by fueling demand, so in most cases simply increasing request and extending and raising limiters for higher rpms is enough.
Really depends what trying of figures your trying to achieve.

[ecutuners]

Check the launch control map too

[pablo1971]

thanks for the replys,

Im only wanting to play around with the idle speed and raise it a little.

[spawns3]

thanks for the replys,

Im only wanting to play around with the idle speed and raise it a little.

If u mean idle rpm use the VAS and u can do this job without searching the bytes for that. A little hint , the RPM map works by ?C and is a 2x1 map. If u mean more RPM u have to change the injector shut off by RPM .

Check this adress : 6D5EA

[daniel guerra]

There's also a single for min rpm, if you change the rpm based on temp, when you reach the desired temp the rpm returns to 903rpm's, you need to change the 903 correct?

[pablo1971]

i will test tomorrow and post results...vas and the 2x1.

thanks for all your help,its appreciated.

:bounce:

[spawns3]

There's also a single for min rpm, if you change the rpm based on temp, when you reach the desired temp the rpm returns to 903rpm's, you need to change the 903 correct?

About the single , use the das to change the rpm , and then read again the flash and find the diference .