Passat_5wp4_immo_off

[mardude]

Please, help immo off Passat Siemens 5WP4 154 037906025, 93c56 plcc 27c010.

Best Regards.

[mardude]

Thanks, problem solved, with file immo off.

[Positron2200]

Hi Dear. Please can you tell me how you did this?. I have the same problemm too.

[Positron2200]

Very thanks.

[DOUGLASDL]

Very thanks. Problemm solvedfriend how to solve this problem thanks

[SergoFox]

Hi mardude! Please tell me how. I need a replacement ECU.

[motortecnica]

Hello, you need to enter more information about the unit, what model and simos 1 (1Plug) 93c56 ....... simos2 (2Plug) EEPROM 27C010

[SergoFox]

Hi, motortecnica!
Here is photo old ECU (same as new ECU).
194510194511

[motortecnica]

sergo we did not have to look if the control unit and a plug or two then plug in the controller looks if you find the two memories that you or referred to in the post above, if you can read and post the files that you do immo off .... let me know!

[Positron2200]

friend how to solve this problem thanks

Dear, what is your ECU?

[SergoFox]

Sorry, simos, 1 plug, 93c56.
i read 93c56 from old ecu, but there have is only FF.
Here are dump from new ecu(93c56):

[motortecnica]

hello sergo,immo off here let us know!

[hauwkee]

hello sergo,immo off here let us know!
how you get to this file using software or manualy

[motortecnica]

hauwkee (http://www.digital-kaos.co.uk/forums/members/60346-hauwkee/) with software, some manual also knowing the areas in hex!

[SergoFox]

tnx. I try this.

[SergoFox]

hello sergo,immo off here let us know!

Tnx, but this don't work.

I soldered the emulator, but it does not work too.
I read immobilizer PIN and tried to snap it as described here: Immobilizer I ECU Swapping - Ross-Tech Wiki (http://wiki.ross-tech.com/wiki/index.php/Immobilizer_I_ECU_Swapping)
but after snapping from the ECU has only one fault: P1570 - Engine Start Blocked by Immobilizer (http://wiki.ross-tech.com/wiki/index.php/17978/P1570/005488)

Any idea?

when the motor is connected to the immobilizer is put as many times as I press the start button but stops after 1-2 sec. And the detached IMMO - only once, until the next ignition cycle.

ps This car have the START button which is connected to the starter.

[adiagnostyka]

You must use immobox solution :) send dump and i'l try to help :)

[SergoFox]

Ok, please..

Motorola 0B91T

195703

[adiagnostyka]

must work :)

[SergoFox]

thanks.
I'll try it too.

[olecram]

Thanks, problem solved, with file immo off.

Could you give me your fixed dump? I have the same problem.
Thanks in advance

[AudiRS44]

Hi,

need also a solution for Passat with 037 906 025 Simos 1 5WP4 154, can somebody switch off Immo?

Flash and E? attached.

Regards,

AudiRS

388917

[AudiRS44]

Has nobody a solution?

Regards