carprog opel astra mt35e problem

[ete3000]

Hi,

I connect the carprog with A1 cable to opel astra with MT35E ecu and the carprog program say "Could not receive CAN kwp frame", what is the problem?

Regards

[mastaflex]

sure it's a clone. some does not work with CAN

[ALEXEI]

good clone work good with can

[tas_daz]

what company have good clone and test by you?

[soxten]

I have the same problem...
How to read MT35E with Carprog?

[atomiczen]

same problem with ori carprog on some mt35e

[diyre]

Hi all, I do not have much to do, but this just give joy. I had the same problem, with MT35E, try reading a previously Vectra from OBD and pin-out and did not connect. Now with that MT35E, same but a different error, I was looking online and found a schematic of connector A1. I opened mine and the surprise was that in the R1 and R4, which should be a SMD 103 (10k) resistance, had mounted capacitor. Look at my scrapping plates and found 103, capacitors replaced it and returned you to try. I read 2 eproom and am now reading the flash. The error was finalized.
I hope you might help. Upload photo with parts A1 to compared yours.
a greeting354649

[elremont]

Hi all, I do not have much to do, but this just give joy. I had the same problem, with MT35E, try reading a previously Vectra from OBD and pin-out and did not connect. Now with that MT35E, same but a different error, I was looking online and found a schematic of connector A1. I opened mine and the surprise was that in the R1 and R4, which should be a SMD 103 (10k) resistance, had mounted capacitor. Look at my scrapping plates and found 103, capacitors replaced it and returned you to try. I read 2 eproom and am now reading the flash. The error was finalized.
I hope you might help. Upload photo with parts A1 to compared yours.
a greeting354649

Thanks friend,this solution 100% work on MT35 ecu.