ews and emulator

[newgeniehex]

hello
i friend have change the mileage on dash and lmc whitout probleme and he have try to change the mileage on the ews but before he don't have read the mask and it is not 0D46J
now the ews is erased!! the car don't start
he have buy a ews emulator whit 3 wire
how he can put in the car he undestand me too
thank in advnce
regard

[bearheroes]

what ecu do you have?

[newgeniehex]

what ecu do you have?
hello
i don't know?
i see and i will report
but i don't undestand where i can put the ews emulator
in the ecu or in the ews?
regard

[bearheroes]

in the ecu.post details of your ecu and maybe someone can help you.

[newgeniehex]

in the ecu.post details of your ecu and maybe someone can help you.
hello
my friend have buy this emulator
how it work???
it work in obd ?or in the ecu ????
many thanj in advance regard

[bearheroes]

post details of your ecu and i'll try to give the steps of installing the emulator.

[newgeniehex]

post details of your ecu and i'll try to give the steps of installing the emulator.
hello
i put the picture of thr ecu
thank in advance regard

[dimitar]

hello
i put the picture of thr ecu
thank in advance regard


immo off possible for this ecu eeprom 93c46

[newgeniehex]

immo off possible for this ecu eeprom 93c46
hello
the car whithout ews don't start
if i turm the key i have nothing in the motor
regard

[immokill]

hello
the car whithout ews don't start
if i turm the key i have nothing in the motor
regard

you need to brick wires on ews connector to enable +50(crank)
Read emu manual .

6. Don t forget to short two starter relay wires (EWS connector)!

[newgeniehex]

you need to brick wires on ews connector to enable +50(crank)
Read emu manual .

6. Don t forget to short two starter relay wires (EWS connector)!
hello
thank but i am a newbie for this working!!
how i cant connect the emulator in my PC?? because i must to chose the port com!!
and i must to have a diagnostique ardware bmw or no???

[diimon]

connect your emulator to + - and k-Line and read
in inpa, read in statuses ISN code and then write that to emulator

[newgeniehex]

connect your emulator to + - and k-Line and read
in inpa, read in statuses ISN code and then write that to emulator
HELLO
thank
if i don't have inpa how i do this job?
it is possible to bridge the relay in the ews and make immo off in the ecu
regard

[adiagnostyka]

use k line vag cable - work with inpa. Or in ews plug bridge pin's and immo off in ecu