BDM100 PIN 1 For MJD 6J0 ?

[darwins]

Hello Friends

I would like to read this but I'm very confused about correct connections, I have looked around forum and this does not clear up how I see it.

It looks like Xprog (Clone) is not good for reading because it does not read whole file....

Maybe FG Tech can read by OBD if the resistor is removed ?

I opt for BDM100 but prefer not to screw the processor so I ask the question first :slug:

There are 2 X Earth connections next to " C " so I'm thinking BDM100 cable pin one is at " C " please help with good result :)

Thanks guys..

Darwins

[nemena]

Do you have the marelli adapter for fgtech? Connect it according to the picture. It should be oriented like on the picture and all will be fine.

[Nio]

Hello Darwins,
Pin 1 is to A point image you post.

[darwins]

Thanks guys....

PIN 1 for BDM100 is A so 2 pins other end are not connected ?

The BDM100 image I have is not clear

Regards

[nemena]

you should not connect A on the left. You should start from B with the terminal.

[darwins]

So now I have another option, Can you see my problem :)

I WANT TO CONNECT BDM100 CLONE..... I KNOW WHERE PIN 1 IS ON THE UNIT I HAVE DONE EDC16 NO PROBLEM..

[nemena]

do you have that little marelli adapter board, shown in my first post?

[darwins]

Hi nemena

No I don't, I can solder wires to pads then connect 1 to 1 with BDM cable to pad.

Thanks

[nemena]

As soon as I get home I take picture of mine, so you'll se the connections.
http://www.hobd2.com/upload/pro/fgtech-galletto-2-master-v5.0-with-bdm-adaptor-39.jpg

[nemena]

Here are the pictures, according to this and fgtech pdf, you will be able to make the right connections

[ppeyup]

Hello Friends

I would like to read this but I'm very confused about correct connections, I have looked around forum and this does not clear up how I see it.

It looks like Xprog (Clone) is not good for reading because it does not read whole file....

Maybe FG Tech can read by OBD if the resistor is removed ?

I opt for BDM100 but prefer not to screw the processor so I ask the question first :slug:

There are 2 X Earth connections next to " C " so I'm thinking BDM100 cable pin one is at " C " please help with good result :)

Thanks guys..

Darwins
hi
the picture here