View Full Version : Volvo V40 Key
treo
10th February, 2013, 09:45 AM
Hi to All
I have to make a key for Volvo V40 2001 year.
I read eeprom 93c66 from immbox and program a blank PCF7035 with ZEDBULL clone using EFfi program,becouse ZED dont recognize the dump ,data on chip is :
0000000000000000
4B8BAE100F0F0101
Problem is car dont start.
What is wrong?
zygzook
10th February, 2013, 03:39 PM
VOLV0 174827
treo
10th February, 2013, 05:55 PM
VOLV0 174827
Explain please what can I do with this dump?
obdmaster
10th February, 2013, 06:41 PM
Ive used zedbull original on same immobox and it worked great.
Try again using zedbull v5.08 to see if effi software has a small glitch.
If zedbull software dont recognise dump, your dump is not good did you read 93c66 off board???
ninja123
10th February, 2013, 07:42 PM
Ive done these with clone zedbull 100% work every time, read with x prog m in circuit too.
ninja
treo
10th February, 2013, 07:44 PM
Ive used zedbull original on same immobox and it worked great.
Try again using zedbull v5.08 to see if effi software has a small glitch.
If zedbull software dont recognise dump, your dump is not good did you read 93c66 off board???
Yes I read out.
In ZED menu dump size is 256kb.
My dump have 512kb,so I can not use ZED prog.
treo
10th February, 2013, 08:25 PM
Ive done these with clone zedbull 100% work every time, read with x prog m in circuit too.
ninja
What size have your dump?
ninja123
10th February, 2013, 08:46 PM
i will have to go to my van and check, but it is snowing BAD so ill check tomorow for you.
ninja
mojomojo
15th February, 2013, 02:41 PM
This is the file I used with tango. Size was 512kb. :ciao:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.