2007 GMC Acadia 25861147 CRASH

[audiotek]

I have a 2007 GMC Acadia with airbag module 25861147, eeprom 95320, I tested some solutions posted in this forum but retrieves DTC B0090_71 (Rollover sesor Invalid serial data), I already reprogram the ROS sensor with Tech2 and says "present" and when finish the reprogramming says "active/ok)" but the airbag light and the "Service Air Bags" message doesn't turn off and the DTC B0090_71 is the only code present. Apparently the SDM module is ok now, I wonder if some one has or had a similar problem and if the ROS sensor needs to be replaced or can be reseted. The initial DTC's B0052 (SDM module needs to replace) doesn't come up again. Here is the original crash file:

[AVDIMON]

Try this dump, but it probably won't help. I had same issue and found that in the repair show someone installed wrong sensor. I was able to confirm with local GMC dealer that sensor ID is wrong. Check out sensor and confirm that part number is matching with dealer number.

[audiotek]

Thanks, tomorrow I'll try your solution and comment. I already check the ROS part number and fits the vehicle by VIN. BR...

[arpi]

in case you need an other

[AVDIMON]

Did you resolve issue?

[audiotek]

No, not yet, I'm waiting the new Rollover sensor, It's the only code retrieved...

[audiotek]

Problem solved!!! the problem was in the main conector pins of the Airbag module, there was two bended pins. All dumps are ok, thanks for your help. BR...

[bilalalib1]

send password please