A3 1997 VDO km counts up fast

[drpeter]

A customer let someone adjust the km with super vag k + can 4.8 and now the original dump is corrupt. I found another dump that's working exept I have a immo problem. Car don't start with the new dump. I changed the pin code in the new dump and the VIN but nothing. Can someone copy the immo blocks for me if possible? Or make the new dump immo off. Thanks. With the original dump the car starts fine.

See attachments for dumps.

[looly]

Hi Peter It is not possible to make immo off in dash, only by reprogramming ecu dump. What is corrupted in the original file as you say the car still starts? BR

Edit:Sorry I see that the problem is km jumping up too fast, hmm...

[maumaumau]

A customer let someone adjust the km with super vag k + can 4.8 and now the original dump is corrupt. I found another dump that's working exept I have a immo problem. Car don't start with the new dump. I changed the pin code in the new dump and the VIN but nothing. Can someone copy the immo blocks for me if possible? Or make the new dump immo off. Thanks. With the original dump the car starts fine.

See attachments for dumps.

write the new dump...adapt cluster to the car and keys to the cluster using vcds

[drpeter]

write the new dump...adapt cluster to the car and keys to the cluster using vcds


member OEP told me how with vcds and it worked perfect thanks all for your help.

Match cluster:

Matching the Cluster to the Engine ECU
[Select]
[17 - Instruments]
[Adaption - 10]
Leave channel at "00"
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
Switch ignition Off and then back On within one minute, but do not start vehicle.
Notes: On some Euro Audi models with Immobilizer II, a PIN will be required.

Then keys:

[Select]
[17 - Instruments]
[Login - 11]
4-digit PIN
Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.
[Do It!]


[Adaptation - 10]
Enter 21 in "Channel Number".
[Read]
The "Stored Value" is the number of keys currently matched.
Enter a "new value" corresponding to the total number of keys to be matched, including any existing keys.
Any old keys are automatically being cleared. All keys, including existing keys, must be matched at the same time.
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
Repeat the following steps until all Keys have been matched:
Switch Ignition OFF and remove Key.
Insert the next Key and switch Ignition ON.
The Immobilizer Warning Light will light up for ~2 seconds, wait until it goes out, indicating that the key has been matched.
Note: The above steps must be completed within 60 seconds after saving the Adaptation!