crowbareight
20th February, 2013, 12:33 AM
Ok,
I know this may seem a stupid question to ask but here goes !
Needing to decode a VW navi unit with the FIS type eprom
Problem is this ( A lot have asked about this but I have yet to see a proper answer to the question) what do I need to use to read the eprom with,
Do I just run a few wires from my little bee+ programmer or what ?
I have seen some equipment out there that has all the bells & whistles.
I do have some good programmers here that perhaps can be used to read the files required to code the unit.
Ie a TMs 370 & other units like a william programmer etc
if not or can be, would someone please shed a little light on the subject.
As some of us are still in the slow lane !! lol !
Thanks in advance !
I know this may seem a stupid question to ask but here goes !
Needing to decode a VW navi unit with the FIS type eprom
Problem is this ( A lot have asked about this but I have yet to see a proper answer to the question) what do I need to use to read the eprom with,
Do I just run a few wires from my little bee+ programmer or what ?
I have seen some equipment out there that has all the bells & whistles.
I do have some good programmers here that perhaps can be used to read the files required to code the unit.
Ie a TMs 370 & other units like a william programmer etc
if not or can be, would someone please shed a little light on the subject.
As some of us are still in the slow lane !! lol !
Thanks in advance !