PDA

View Full Version : edc17cp20 vw crafter start problem



moddder
20th February, 2013, 04:39 PM
Hello,
We have VW crafter 2.5tdi with edc17cp20 tprot,
After tuning car started ok , drive for about 30 mins ok. Then on morning no start, turn key on tacho OK all lamps ok but starter not run.
Full original back and again no start, DTC's none.
From pull car started ! we have checked starter - OK
If we manually give signal on starter car starts, from first view it looks like signal from key not reaches starter.

Does any one have experience in that situation or know where to look ?

camil
20th February, 2013, 04:53 PM
Try unplug and plug again the ecu, maybe misscontact.

moddder
20th February, 2013, 06:33 PM
Try unplug and plug again the ecu, maybe misscontact.

Done several times (((

bobolin4o
20th February, 2013, 06:39 PM
Starter relay, fuse, etc.

pablo1971
20th February, 2013, 09:45 PM
if you manually add signal to starter and the car runs....and it runs for lets says 3 mins...then all is ok...immob all ok....


immob cuts fuel,

if this is the case and it runs ok with you adding signal,then i would say there is a problem with the van....check and see if there is a starter relay...check the signals in the relay.

maybe you will find a fault there

moddder
20th February, 2013, 11:31 PM
Yes , if we add signal to starter the car runs ok, much more than 3 min.
We aregoind to check all relays tomorrow and hoping that it is not ecu related problem. Will write the resaults tomorrow !

if you manually add signal to starter and the car runs....and it runs for lets says 3 mins...then all is ok...immob all ok....


immob cuts fuel,

if this is the case and it runs ok with you adding signal,then i would say there is a problem with the van....check and see if there is a starter relay...check the signals in the relay.

maybe you will find a fault there

moddder
25th February, 2013, 01:25 PM
Car is fixed, the problem was with fuse .

Thanks to every one !