307 bsi pinout

[igorr]

can someone give me pinout for bsi peugeot 307
valeo j04-00
thee is no 95160 on front side

[kizagt]

can someone give me pinout for bsi peugeot 307
valeo j04-00
thee is no 95160 on front side
It is inside no in the front side of bsi

[cheester]

Have same problem. Mine bsi is valeo K02 from 307 2005.
Epprom between two boards. I have done good reading and its no easy to do this bsi. Data can be very easy corrupted reading in circuit via solder points on the back.
There is no many posts about this, would like to know what is the best and safety way to do it?
Someone have 100% working solution for this bsi??

Smok tool can do it via obd but 05-up...

[kizagt]

I think that best solution is to desolder two bords of bsi and than desolder eerpom and read on external programmer.

[batandball]

Try this one mate

[cheester]

Batantball have you try this solution? Its for TU right??
Working 100% ??
Someone have done tbis ecu by upa usb.

[batandball]

I've used these connection for different machines and it works fine, as for UPA even though I have it, I've never tried it on the BSI

[darius89]

these for 912dg128

[Motika]

Someone posted an easier method of altering the mileage using a screw at the back of the dash. Have not tried it myself. Search forums and you will find it

[cheester]

Batantball and you never corrupted the file reading in circuit bsi?
Reading with ups should be done with 5v or 3.3v?

[kizagt]

Batantball and you never corrupted the file reading in circuit bsi?
Reading with ups should be done with 5v or 3.3v?
Read with 3.3v i successful read in circuit only few times i preffer to open bsi. I don t know when i do mestake when i read in circuit...

[3abas27]

I TEST THIS SOLUTION BUT NOT WORK FO R ME WITH UPA

[gepakg]

for sure work with UPA,but on 3.3V

regards Gepa


I TEST THIS SOLUTION BUT NOT WORK FO R ME WITH UPA

[shtyrya2]

Try this one mate

Where is the pin 8??? pin 8 is VCC! Or you guys read the memory with BSI connected? Thanks!

[autocargo]

Digiprog working very good also... Done a few...
249949

[gejzaslapka]

Yes on 3,3V reading correctly

GS

[p1et]

Hi,

Where to change in UPA from 5V to 3.3V? I can't find anywhere how to change this. Only thing I can see is chip type 'M25P10 - 3.3V' and couple simmilar just above ST95160 on the list

EDIT:

OK, I tried with Xprog and read + verify OK. But the BSI is probably corrupted, can someone check this file for me? Car came to me without working key with flat battery. I tried read pin via OBD after battery re-charge but no luck. Now lack of some electricity in car ie. not working wipers, some lights, turn signals OK but cannot hear them. I don't know if flat battery caused this or my tool when I was trying to read because I have no idea if those thing were working before car came to my workshop.

[samsunguser1001]

Try this one mate
thanks mate