Fiat Ducato 2.3 jtd immo off 0281014209

[mellon]

Hi,
I need immo off in fiat ducato 2.3 jtd 028101420. I post eprom 95640 and full bdm read. What is difference by immo off partial and total.
Best regards
Adam

[bearheroes]

post the flash dump.

[mellon]

There is bdm file 600kb. In this link lupu_sandu says that is ok
http://www.digital-kaos.co.uk/forums/f175/edc16c39-0281014209-a-210043/
post #6

[mellon]

This is flash and eprom from export by bdm100.

[benci1982]

This is flash and eprom from export by bdm100.

hi. try this file. tested work 100% the file is whitout checksum.

[mellon]

hi. try this file. tested work 100% the file is whitout checksum.

Not working! The key light on dash light and car not run. I count chksum.

[benci1982]

Not working! The key light on dash light and car not run. I count chksum.

hi. yes the key light must light. connect the car to pp2000 and look the dtc! this immo off method i using, and tried to min 40 car and it is work.

[furnata]

Try Benci's dump but remove immobox before

[lupu_sandu]

This is Ducato 3, no immobox in this car. This car have BSI

[mellon]

So, thanks for help. Client bring to me only ecu because someone told him about immo problem in this car. I remove immo with Bencis dump. Car not run. I checked dtc and I have no communication with ecu. Than I program ori dump and tha same problem. There is power distribution problem. I don't have 12V from battery on pin 1 and 5 in ecu K plug. There is only 12V after ignition. I havo to check wiring.

[mellon]

or this is ecu, because 12v on pin 5 and 1 ecu is coming from master relay which is controled by 72 pin ecu (gnd signal)

[mellon]

One broken wire from 72pin ecu tu master relay.

[didi_du_93000]

hi. try this file. tested work 100% the file is whitout checksum.

Hello, when you say "the file is whitout checksum", you talk about must calculate cheksum? or no need to calculate cheksum.

[kire106ka]

Without checksum means that you have to calculate if tool you are flashing with not calculate check.... always check does you tool calculate checksum

[didi_du_93000]

The "calculate cheksum" from Xprog M working great?

It's question.

[gyapi11]

No. No good X-prog

[didi_du_93000]

Can ou explain why?
Xprog read good

[didi_du_93000]

Xprog M Checksum option.
Value is 6510.

So is good Value or Not?