PDA

View Full Version : Renault Megane 1.9 dCi EDC16C3/9 Unable to read by OBD



enigmauk
24th February, 2013, 10:03 AM
Renault Megane 1.9 dCi EDC16C3/9 Unable to read by OBD

It will give me the ECU ID but it failed to read by OBD, I just wanted to know if there is a special procedure to put the ignition on these or something?

It was reading sometimes 1% to 7% then stopped...

furnata
24th February, 2013, 10:08 AM
Maybe the car is don't have enough voltage. The car is with card-key??

Babos
24th February, 2013, 10:42 AM
What tool you use for this job?
Mpps can lost InjectionCodes after writing.
Fgtech2 do this job very well but need read manual!
If you have cardkey need push and hold start button 10sec!
And write ecu after enginet temprature need be low 50C.
Best regards.
Babos.

kevfield
24th February, 2013, 04:44 PM
I also used fgtech for this , must keep power up on car when writing fan is on , also make correct ignition cycle at end of write! read what fgtech tells you if not it makes bad write.....

Thanks kev