darwins
25th February, 2013, 07:32 PM
Hello Friends.
I like this red box CAS3 tool but the files read are not helpful for ISN work, spent loads of time trying to read a CAS2 today as I did a CAS3 before with Xprog & UPA original latest software but get nowhere..
So I take the chip off and read with ETL for great accuracy not a pleasure with all the glue under this thin package, done a few now but it is sure slow compared with CAS3 connections & read..
Does anyone have a good file convertor tested from CAS Red box to BIN format and back again ?
Or tested Xprog connections which work, I'm starting to think it's my clone Xprog which is the problem, it goes through security bypass then sits there forever, I'm using a 15 Volt power supply..
Any suggestions appreciated..
Darwins
I like this red box CAS3 tool but the files read are not helpful for ISN work, spent loads of time trying to read a CAS2 today as I did a CAS3 before with Xprog & UPA original latest software but get nowhere..
So I take the chip off and read with ETL for great accuracy not a pleasure with all the glue under this thin package, done a few now but it is sure slow compared with CAS3 connections & read..
Does anyone have a good file convertor tested from CAS Red box to BIN format and back again ?
Or tested Xprog connections which work, I'm starting to think it's my clone Xprog which is the problem, it goes through security bypass then sits there forever, I'm using a 15 Volt power supply..
Any suggestions appreciated..
Darwins