PDA

View Full Version : Chrysler bench connections


sogaro
1st March, 2013, 08:27 AM
Would like to know if its possible to connect a Chrysler ECU and SKIM/SKREEM on the bench for immo programming and ECU flashing. Experts opinion


Sent from my iPhone 4s using Tapatalk
eeddyy23
4th March, 2013, 08:56 AM
Would like to know if its possible to connect a Chrysler ECU and SKIM/SKREEM on the bench for immo programming and ECU flashing. Experts opinion


Sent from my iPhone 4s using Tapatalk
yeah i believe it is possible never try it but looking at the diagram seems easy
sogaro
4th March, 2013, 12:25 PM
let me know how it goes
eeddyy23
5th March, 2013, 04:18 AM
let me know how it goes
post more info year and kind of vehicle
sogaro
5th March, 2013, 04:23 AM
All kinds, if you have any let me see it


Sent from my iPhone 4s using Tapatalk
koncimobil
12th March, 2013, 03:46 PM
Maybe this tool ?
Off Board Programming Cable Set Adapter GM Ford Chrysler J2534 Benchtop | eBay (http://www.ebay.com/itm/360458526416?item=360458526416&viewitem=&sspagename=ADME:X:RTQ:MOTORS:1123&vxp=mtr)
vengiens
13th March, 2013, 02:28 AM
it can be done i have a setup for dodge caravan 2002 you need the DLC, ecm ,bcm and skim and the connectors.
Hook up all the feeds and grounds from all connectors to a 12v source put a switched source on all ign feeds then you need to hook up the flash enable on mine white/brown to bcm and the pci bus to all modules all hooked to gether white/vio and the sci transmit and receive from dlc to ecm and you should be good to go

i have tested this and it worked to reprogram the ecm vin to reprogram sri and clear immo data from a ecm.
To program the skim you would need a drbIII

You will need connector pin out diagrams for all your modules other wise you would be guessing