PDA

View Full Version : Audi a8 4e0 me 7.1.1 checksum error


golona88
3rd March, 2013, 11:03 AM
Adi a8 2006 r 6.0 engine -1 ,fault code 19553,p3097-001
checksum error,ecu 4e0 906 018 bosch 261 208 714
dump 29f800 bb,engine starts work bumpily
Babos
3rd March, 2013, 11:21 AM
what tool you use for this job?
golona88
3rd March, 2013, 11:26 AM
There was not tuningu,I have read beeprog elnec,
There is origina***322; dump
Babos
3rd March, 2013, 11:29 AM
your flash is bad!!!
golona88
3rd March, 2013, 11:33 AM
bad reading or bad flasch ?
Babos
3rd March, 2013, 11:34 AM
read!!! and after you write this one?
golona88
3rd March, 2013, 11:35 AM
I did not touch earlier
Babos
3rd March, 2013, 11:39 AM
maybe after this procedur car lost enjectin code?
asking maybe who know, reprograming ecu with VAS 5054a
it is good tool for VAG and not expencive.
golona88
3rd March, 2013, 11:50 AM
I think read new dump.but not have
veloseeped
3rd March, 2013, 12:35 PM
your flash is bad!!!
Not correct. Flash dump is OK.
The csm error problem is not in main flash.

golona88, do you sure that ECU 1 and 2 are not swaped from original positions?
golona88
3rd March, 2013, 12:55 PM
positions its ok 100 %
Maybe error is in sp08c3

It has become from day on day so,It repaired nobody, There is my private car,Never it was problems,
I send dump sp08c3
filecloud
3rd March, 2013, 12:56 PM
Hello
Flash is 100% original. The error is typical if ecu 1 and 2 have been swapped!! Eeproms are corrupt.
grretings,
filecloud
golona88
3rd March, 2013, 01:16 PM
As I changed place ecu engine not starts !!
As position is good -
engine works, car drive but ,cluster shows error ,Probably, not ideally
filecloud
3rd March, 2013, 02:59 PM
As I changed place ecu engine not starts !!
As position is good -
engine works, car drive but ,cluster shows error ,Probably, not ideally

That was exactly the problem! You must NOT swap them! When you have done it once the eeproms are corrupt and keep the errors.
greetings,
filecloud
golona88
3rd March, 2013, 04:45 PM
So, I must make that in order to delete this error
golona88
3rd March, 2013, 09:33 PM
Helo
I have installed new use ecu,I soldered only sp08c3 from old ecu And there is good,ride 50 kilometers cluster is clean but it shows vcds P1647 - 001 ,I can not cancel it error?
have only vcds adako
Babos
3rd March, 2013, 09:38 PM
P1647 - 001 it is mean not corect coding.
golona88
3rd March, 2013, 09:47 PM
But I know but I checked coding the same is, mayby make adaptation ?