zuranic2
10th March, 2013, 05:39 PM
Hello,
I try to change mileage on this dashbord with Ponyprog trough 8-pin adapter. It has 417893km.
I upload new dump with 500000km and resolder chip back to board.
Now odometer show CODE. When I start test mode shows 333333 or CODE in test steps.
What am I doing wrong? Is it possible to change dump directly in Pony like I did or I need HexWorkshop?
Is it possible to code odo with DIS to get it work, or I need to upload new dump?
I try to change mileage on this dashbord with Ponyprog trough 8-pin adapter. It has 417893km.
I upload new dump with 500000km and resolder chip back to board.
Now odometer show CODE. When I start test mode shows 333333 or CODE in test steps.
What am I doing wrong? Is it possible to change dump directly in Pony like I did or I need HexWorkshop?
Is it possible to code odo with DIS to get it work, or I need to upload new dump?