Pinout Mercedes Temic CRV 2.0

[alclot]

Good morning gentlemen. I tried to check this ecu in workbench but I have no scheme supplies and communications line. I found a schematic of Fgtech2, but when I give 12 volts is shorted. Do not understand how Galleto, put that scheme. Do you have an outline ok, to check it?
Thanks in advance.

[alclot]

Any solution? help please ;(

[alclot]

Hi again. I tried to read the micro ST10F269 also with xprog-m. I also do not read it. Did someone help me read this unit?
Thanks in advance ;)

[zoyzoyni]

DID YOU USE THIS CONECTIONS??????

[alclot]

DID YOU USE THIS CONECTIONS??????
Hi. This isn?t same ecu. This is for truck.
Regards ;)

[gameiruz]

I there, i have the same issue, is there a solution for this?

Thank you and best regards.

[buul]

I had the same problem. Connection from from first post is OK you need strong power supply. 20A is ok :)

[Georg1]

Hello, I connected it like on picture and power supply is strong enough but I don't get an ID in bootmode with Byteshooter