View Full Version : range rover 1996 M28c16 km change please 125000KM
blerim shehi
27th March, 2013, 05:43 PM
range rover 1996 M28c16 km change please 125000KM
CARPARTS
27th March, 2013, 06:27 PM
Here is
do not forget to reset the BCM first off all before you put back the dash
batandball
27th March, 2013, 06:38 PM
You can reset BCM by putting dash back in vehicle without chip in, turn ignition on for a few minutes, them take dash back out and replace chip
blerim shehi
27th March, 2013, 08:56 PM
THIS IS EEPROM MOTOROLA 1E59B
teerak2uk
27th March, 2013, 10:28 PM
THIS IS EEPROM MOTOROLA 1E59B
Like batandball said it will reset if you place the dash back in with out chip and run for a few minutes.
What did you read dash chip with?
teerak2uk
27th March, 2013, 10:38 PM
Digiprog procedure (in broken english)
Expand the instrument and remove the rear Kunststoffab-cover.
Search the OKI28C16A chip and solder him by the Board.
Now refit the instrument cluster and make the ignition for 2 minutes.
Reconstruct the speedometer. Put the OKI28C16A chip on ST40 (point of chip to PIN 1, see plug view) and associate it with the DIGI PROG.
Choose the program: car / truck - Land Rover - RANGE ROVER CHIP. The DIGI PROG shows you the current mileage. Give the new mileage
blerim shehi
28th March, 2013, 10:48 AM
THANKS FOR YOUR HEL...EVERYTHING GOES OK..
teerak2uk
28th March, 2013, 10:55 AM
THANKS FOR YOUR HEL...EVERYTHING GOES OK..
What h/w did you use to read/write to chip with
SDO
27th June, 2013, 12:13 PM
Does digiprog clone come with ST40 adapter ? I looked everywhere but can't find one
teerak2uk
27th June, 2013, 05:52 PM
No it don't come with it and original adaptor is expensive especially if it don't work so maybe better to buy willem programmer
for this
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.