View Full Version : ETL PROGRAMMER
timos
30th March, 2013, 03:53 PM
Hello.
Anybody help me please?
I bought an etl programmer clone.I tried to read MC9S12DG256 mask2K79X and after the SRART message programmer is
Vreg Output Voltage Out Of Range[lower]
Thanks in advance
elservis
30th March, 2013, 11:27 PM
You read in circuit or onboard? Read pdf manual. Vreg Output Voltage Out Of Range[lower]-Hardware problem in programmer
leandroks
31st March, 2013, 03:11 AM
Be carefull with 9s12 when reading with clone etl it can burn the mcu, it happens to me many times..
timos
31st March, 2013, 07:37 AM
I read it on board.What you mean leandroks be carefull?What can i do for be carefull?
gadroulll
31st March, 2013, 08:24 AM
you problem is in soldering test them cAREFULLY. NEVER clone has fail to me with this mcu
Shmortz
9th August, 2013, 05:23 PM
I have the same problem, solderings are good, timos did you find where the problem is?
marusca
14th August, 2013, 08:27 PM
what source you put in etl.... 12v stabilized?
Alexuko
14th August, 2013, 10:11 PM
NEVER clone has fail to me with this mcu
desoldering mcu
Pzolee
25th January, 2018, 06:24 PM
Hi.
I same problem. Desolder mcu not work. What solution?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.