PDA

View Full Version : piasini s3000 write



nemena
3rd April, 2013, 09:55 PM
Hello All,

Could someone tell me why I cannot write sagem s3000 ecu?
Connection is according to the schematic. Reading is ok.
For writing I Install 2 additional jumpers. --- "No Ecu found"
How much should be the programming voltage? And which pin?
Thank you in advance:
Peter

furnata
5th April, 2013, 07:51 AM
What tool u try?
Piasini or other- i have success with piasini clone np at all

nemena
10th April, 2013, 02:26 PM
I have clone piasini, but it does not write the ecu. I am only able to read it. Could you send me a high resolution photo of your piasini pcb?
Do you use the pdf for reading/writing?

rocris
29th May, 2013, 07:34 AM
I have clone piasini, but it does not write the ecu. I am only able to read it. Could you send me a high resolution photo of your piasini pcb?
Do you use the pdf for reading/writing?

Hi,
finally was you able to write it?

car_soft_gorj
27th September, 2013, 10:30 AM
i have same problem ! read ok with piasini flash mache 2 bridge conexion
Execute crc ...ok
****yzing ECU ........
No ECU found, please check wiring. please help :blue:




thanks!

biktel
18th August, 2015, 11:14 AM
same problem with writing this ecu. read is ok. any ideea to this problem?

ghost9800
31st October, 2015, 12:15 AM
hi, with fgtech 54 euro no succes to write, but read ok

panos_k
27th October, 2016, 09:23 AM
Hello,
I have clone piasini, i can read the ecu but I can' t write it.
Has anyone found solution for this.

furnata
27th October, 2016, 09:35 AM
You use resistor 680ohm or 470ohm or no?

panos_k
27th October, 2016, 11:02 AM
I have try with 680ohm, 480ohm, 1k and without resistor but was unable to write it.

furnata
27th October, 2016, 11:10 AM
Check your soldering work bro Piassini clone work like a charm on that ecu

panos_k
27th October, 2016, 11:36 AM
ok i will check the solder.