Read PIN in RB4 crypto via Vag eeprom programmer

[pox]

Hi

I wanna ask about how to read PIN/SKC in Audi A4 RB4 Dash.

1. Connect KKL USB cable to Car and PC
2. Run Vag Eeprom Programmer 1.19
3. In Options select USB
4. Select Dash -> Bosch -> Audi A4 (Encrypted) -> Read Eeprom (Encrypted)
5. File -> Save AS (encrypted backup file)
6. Select Dash -> Bosch -> Audi A4 (Encrypted) -> Set Newmode
7. Select Dash -> Bosch -> Audi A4 (Encrypted) -> Read Eeprom (Decrypted) - inthis step we see full info and Immobilizer PIN
8. File -> Save AS (Decrypted backup file)


Is it everything or is there another step:
9. Select Dash -> Bosch -> Audi A4 (Encrypted) -> Set Back to Adaptation Again

[szogun0]

Just try :tongue:

[pox]

But could you answer for question?

[ninja123]

WHY? If you only need pin code, there is no need to manipulate the dump as you will not need to write back to dash, just unplug and smile at your pin code :)

ninja

[pox]

So I dont need to Set Back to Adaptation Again ?

[cjawahir]

Lupu had a post about this , first you need to set it to mode 4 , read and when finish set back to mode 6 .

cj

[tiguan]

thanks to lupu_sandu
Audi RB4 - YouTube (http://www.youtube.com/watch?v=sTj2WgUZonY)

[pox]

Is possible to crash Rb4 crypted Tacho by seting to 4 mode reading decrypted eeprom and back to 6 mode?

[szogun0]

Yes. It is possible. Especially if write EEPROM.

[sroka]

hello i want change dash on my audi a4 2001y my dash 8e0920900G mono on 8e0920930J iam read eeprom vagprogrammer please help me adaptation immo for this car303193303194

[sroka]

anybody help?