Pin data for renault magane 2004 1.5dci

[garagetech]

Please can someone post ecu 3 plug pin data for 1.5 dci pindata, there is camshaft sensor faukt but change sensor still same fault?

Thanks

[paulinter]

What's the engine and mate. 5 types. None with pin data just a diagram.

Sent from my GT-I9100 using Tapatalk 2

[rideon]

:biggrin: Just send the car back to the mechanic that did the belt job....

[garagetech]

:biggrin: Just send the car back to the mechanic that did the belt job....

The job was done by a machanic apparently 2 years ago after that car running ok

[rideon]

NOT sure if is a 3 wire sensor should be gnd\signal in the middle\12 v

[shadow12]

normally when this fault appears and cam sensor ok, its due to pump pulley timing incorrect

[garagetech]

normally when this fault appears and cam sensor ok, its due to pump pulley timing incorrect

Here is type details
http://img.tapatalk.com/d/13/04/15/4ame5yga.jpg

[garagetech]

Here is type details
http://img.tapatalk.com/d/13/04/15/4ame5yga.jpg

Please anyone give me the wiring details

[rideon]

So... did you check if the sensor is plugged in??
Is there a 12V and a GND when ignition on:questionmark: