kalelarga
9th April, 2013, 07:40 PM
How to activate a special function in DAS 05/2011, so I programmed the SBC module that shows the error:
C249F OPERATING TIME OF COMPONENT A7 / 3 IS EXCEEDED (SBC HYDRAULIC UNIT).
I know the procedure, but my software does not offer this option.
Earlier in the program, 03/2009 (German) had that option and I've successfully worked, but version 05/2011 (English) does not work.
In Developer mode you need to go to Entwickelingsdaten - > ansteueringen -> Gesamstliste aller Ansteuerungen
to see how many times brake has been pressed there is a line that says: Bremsenzahler (DJ_GetBrLive)
then 1 line down there you see Bremsenzahler aktualisieren und Lebensdauerzahler F neu berechenen -> click it !
Parameter uINBR = 0
then click F3
1 line down Bremsenzahler auf beliebigen Wert setzen (DJ_SetNBr) -> click it
Parameter uINBR = 0
then click F3
then scroll down untill you see the line's :
Lebensdauerzahler F neu berechenen (DJ_CalcLiveTime)
Parameter uINBR = 0
then click F3
Lebensdauerzahler F neu berechenen und schreiben (DJ_BuildAndWriteF)
Parameter uINBR = 0
then click F3
Log out of SBC !!
log out of verhicle !!
Thank's
P.S.
Photos are from SIM DAS!
It is the same in the work program!
C249F OPERATING TIME OF COMPONENT A7 / 3 IS EXCEEDED (SBC HYDRAULIC UNIT).
I know the procedure, but my software does not offer this option.
Earlier in the program, 03/2009 (German) had that option and I've successfully worked, but version 05/2011 (English) does not work.
In Developer mode you need to go to Entwickelingsdaten - > ansteueringen -> Gesamstliste aller Ansteuerungen
to see how many times brake has been pressed there is a line that says: Bremsenzahler (DJ_GetBrLive)
then 1 line down there you see Bremsenzahler aktualisieren und Lebensdauerzahler F neu berechenen -> click it !
Parameter uINBR = 0
then click F3
1 line down Bremsenzahler auf beliebigen Wert setzen (DJ_SetNBr) -> click it
Parameter uINBR = 0
then click F3
then scroll down untill you see the line's :
Lebensdauerzahler F neu berechenen (DJ_CalcLiveTime)
Parameter uINBR = 0
then click F3
Lebensdauerzahler F neu berechenen und schreiben (DJ_BuildAndWriteF)
Parameter uINBR = 0
then click F3
Log out of SBC !!
log out of verhicle !!
Thank's
P.S.
Photos are from SIM DAS!
It is the same in the work program!