BERLINGO HC08 UPA

[motorsport]

Hello have meet some problem for read this mcu pin 1 and 2 is lift
devise say read success but dump is empty !!!

[PETAR]

i always make this mcu out of board

[drpeter]

You must lift pin 2 and 3 IRQ upa 1 (pin 2 908) and reset pin 7 (pin 3 908) autobaud sec. bytes off.

[maciupiciu]

for mask 1J35D it's no need to lift any pin, set baud rate ( for 4Mhz) if use UPA.

[BeianM]

you would normally need to lift PTA0 pin 26

[davecooper47]

I never lift any pins for UPA on this micro.

[motorsport]

you can show connection you use?

[motorsport]

have already make 4mhz and auto baud not work
have test too elprosys dont work say time out !!

[BeianM]

for mask 1J35D it's no need to lift any pin, set baud rate ( for 4Mhz) if use UPA.

I just did an Espace body controller with this mask. It would only read with the minimum of pin 3 lifted
the dash has a 908 with mask 2j74y it would only read with all three pins lifted using UPA

I just wish I could read without lifting pins :)

[motorsport]

have lift reset and irq

[motorsport]

I just did an Espace body controller with this mask. It would only read with the minimum of pin 3 lifted
the dash has a 908 with mask 2j74y it would only read with all three pins lifted using UPA

I just wish I could read without lifting pins :)

good can you post your conection picture

[BeianM]

See this from Gophel in downloads. http://www.digital-kaos.co.uk/forums/downloads.php?do=file&id=1261&act=down&actionhash=1365893351-884059c8f3bc186193faaceae8fe1f9a205a8d82

And this http://www.digital-kaos.co.uk/forums/downloads.php?do=file&id=1259&act=down&actionhash=1365893933-e3ff5607ba3aa8c06325ae4130b5e8fbe508152d

upa pin 908 pin
1........... 2
7........... 3
2........... 26
6........... 60
8........... 61
3........... 63

9 to power the board +v
shield power -v

[motorsport]

i cant see 2 link

[BeianM]

i cant see 2 link

HC08AZ60_1J35D_pinout - Downloads - Digital Kaos (http://www.digital-kaos.co.uk/forums/downloads/car-dumps-database/34/hc08az60_1j35d_pinout-1259/)

[motorsport]

HC08AZ60_1J35D_pinout - Downloads - Digital Kaos (http://www.digital-kaos.co.uk/forums/downloads/car-dumps-database/34/hc08az60_1j35d_pinout-1259/)
you have conection for berlingo?

[BeianM]

How have you got on with this? I dont have a berlingo board, sorry. You just need to use the connections above & find where to power the board.

http://youtu.be/UUftobh4dTM