EDC16c34 Boost

[lucim12]

Hello to everyone
I need your help with this
I have removed dpf with ecusafe 1916 because it was the only one that worked. I also removed the muffler, now that the flow has increased i have an over-boost situation

I need to adjust turbo maps but I'm not sure how to do that. Will ECM work ? is it worth trying or is it better manual with winols





please help

[xtreem]

winols is better

[lucim12]

Ok , so apart from turbo pressure maps what ales there is to adjust?

[ominimicu]

turbo limiter must be above turbo pressure or it will cause your current fault error DTC

[lucim12]

Turbo limiter map is in 1eaf00 , is this correct?

[ominimicu]

yes, looks like it

[lucim12]

Can you please tell how to decrees values to it I do not understand this one..

[ominimicu]

Same way as turbo pressure, just normally mod your your turbo map, afterwards check to see if in any moment the turbo pressure goes above the limiter. If so also raise limiter

[lucim12]

thanks, there is 6 turbo maps also there are other two that look like turbo map in 1c34cbc , 16eab8 can you tell what they are please?

[ominimicu]

yes 6 turbo maps. 1c34 that is an EGR map , and 16eab8 is nothing.it may seem like a turbo but its nothing.

do you register pressures above 2,2 bar? even if you have more flow beacsue of the no cat. the turbo electrovalve should limit it to what the map specifies.

[lucim12]

Yes , the pressure goes up to 2.5 bar which is the limit of the map sensor (also tryed with a replacement sensor)
So turbo limiter map in 1eaf00 looks like this? I'm a little confused

[smayer]

Just post original file to someone remove DPF with manual solution.

[lucim12]

I posted ori file above..

Does anyone know where the single value boost limiter is ?

[lucim12]

solved ! :congrats:

[Theoros]

What was the solution?

[lucim12]

the n75 maps

[lucim12]

needed quite a bit of adjustments ..

[lucim12]

the n75 maps